ECU TECHNICAL RESOURCES / MODELS · WIRING · SOFTWARE
ECU Technical Resource Centre
Find ECU input/output information, wiring definitions, sensor calibration, software connections and troubleshooting by model and series.
Technical notes & wiring
Link CAN Lambda: wiring, network setup and diagnostics
CAN Lambda sensor connections, power, bus configuration, warm-up states and troubleshooting.
Updated
Read technical notesTechnical notes & wiring
Bosch LSU 4.9: controller, installation and signal definitions
LSU 4.9 controller requirements, temperature limits, installation position and connector signals.
Updated
Read technical notesTechnical notes & wiring
AEM 30-3300 V2: installation, tests and Boost Safe
30-3300 V2 fluid routing, nozzle position, progressive control, Boost Safe and fault tests.
Updated
Read technical notesSoftware Information
F/IC software: USB connection, tables and logging
Check F/IC USB connection, drivers, load axes, correction tables and logging.
Updated
Read technical notesSoftware Information
Unichip: hardware identification and tuning paths
Unichip piggyback operation, map editing versus file loading and interface identification.
Updated
Read technical notesTechnical guide
Plan ECU inputs and outputs before choosing a model
Turn your engine and retained functions into a practical selection checklist.
Updated
Read GuideTechnical guide
Harness planning: routing, labels and grounds
Plan harness routing, pin labels, sensor and power grounds, then check continuity and shielding.
Updated
Read GuideTechnical guide
MAP sensor selection and calibration checklist
Check MAP pressure reference, range, supply, output calibration and connector pins.
Updated
Read GuideTechnical guide
Wideband lambda: sensor, controller and ECU connection
Understand the parts of a wideband system before choosing a sensor or CAN module.
Updated
Read GuideSoftware Information
PCLink: match the ECU generation and keep a backup
Prepare a supported PCLink connection, identify the ECU generation and preserve a configuration backup.
Updated
Read technical notesTechnical guide
Data logging: channels, sampling and fault reproduction
Select diagnostic channels and sample rates, preserve maps and conditions, and compare logs before and after changes.
Updated
Read GuideSoftware Information
MTune: connection diagnosis, trigger and output tests
Diagnose MTune connection issues using trigger scope, synchronization logs and output tests.
Updated
Read technical notesPRODUCTS / SALES SUPPORT
Need a different manual or software version?
Share the exact controller, hardware revision and computer system so the applicable reference can be checked.