MAP sensorMAP Sensor
$59.43–65.70
Manifold absolute pressure sensor providing a pressure signal to the engine management system.
PRODUCT / CAN LAMBDA COMPONENT
PHOTO 01 / 04PACKAGE CONFIRMED BEFORE PURCHASE
Lambda component
CAN Lambda Component
CAN Lambda components for integrating air-fuel ratio measurements into an ECU system.
Reference unit price$375.40–414.93
Reference prices vary with exchange rates and the supplied package. Contact customer service to confirm the price, shipping and taxes.
01 / About CAN Lambda Component
About CAN Lambda Component
Link CAN Lambda converts the measurement of a compatible Bosch LSU 4.9 sensor into digital CAN lambda data, and each sensor needs its own controller. The item is offered as a complete kit, as a controller on its own or as a replacement sensor, so the supplied scope is confirmed with each quote.
02 / Specifications
Specifications
- Reference model / part
- CANLAM / 125-1000
- Wideband lambda
- Reference kit: Bosch LSU 4.9; lambda 0.67–10
- CAN communication
- 125 / 250 / 500 kbit/s; 1 Mbit/s
- Operating supply
- Reference module: 6–23 V; maximum continuous draw 3 A
- Connector / termination
- 4-way Deutsch power / CAN; LSU 4.9 connection
- Sensor calibration
- No free-air calibration required for the reference kit
- Application reference
- Link G4+ / G4X / G5; other ECUs need Link CAN Lambda protocol support
03 / Package contents
Package contents
The actual supplied contents are confirmed in the itemized quote. Check the following items before payment.
Ask whether the price covers a controller, sensor or kit, and which harness and connectors come with it.
04 / Fitment & installation: CAN Lambda Component
Fitment & installation: CAN Lambda Component
Check the model, hardware revision and connector pins against the device’s wiring diagram.
Use the exact ECU wiring diagram; verify every circuit for continuity and shorts before connecting power.
Match the CAN speed and sensor address, provide protected heater power, and follow the ECU's CAN termination requirements. Plug-in ECUs may need additional CAN-access cables.
05 / Questions about CAN Lambda Component
Questions about CAN Lambda Component
Can CAN Lambda use LSU 4.2?
Link CAN Lambda uses Bosch LSU 4.9; changing the connector does not make LSU 4.2 compatible.
Does Link CAN Lambda require free-air calibration?
Link CAN Lambda with a matching Bosch LSU 4.9 needs no free-air calibration. For replacement, verify sensor type and trim resistor; other controllers may use different calibration procedures.
Can several wideband sensors share one CAN Lambda module?
No. Link specifies one CAN Lambda module per wideband sensor. Compatible Link ECUs can support up to eight modules; multi-sensor installations require the correct CAN speed and unique sensor configuration. Confirm ECU-specific limits and wiring first.
Can a CAN Lambda module work with any ECU that has CAN?
The ECU must understand the Link CAN Lambda message format as well as use the correct bus speed and wiring. A CAN connector by itself does not prove protocol support; confirm the exact ECU and firmware.
06 / Manuals & resources
Manuals & resources
EXPLORE / Related products
