Applicability
Link G4X XtremeX; do not substitute the earlier G4+ wiring file.
Model and software
XtremeX provides eight injector, eight ignition and eleven analogue voltage inputs. It lacks FuryX’s internal LSU 4.9 driver; lambda measurement needs an external controller and a matching signal format.
I/O and electrical limits
A shared pin can perform only one function at a time. Check physical pin overlap when allocating CAN, digital inputs, throttle and auxiliary outputs.
| Item | Specification / revision condition |
|---|---|
| Model / part number | 109-4000 |
| Engine configuration | 8 sequential cylinders / 4 rotors |
| Injector outputs | 8 |
| Ignition outputs | 8 |
| Auxiliary outputs | 10 |
| Analogue inputs | 11 |
| Digital inputs | 10; two consumed by the second CAN bus |
| Temperature inputs | 4 |
| Trigger inputs / signal | 2 |
| Knock inputs | 2 |
| CAN communication | 2 |
| Wideband lambda | External wideband controller required |
| Electronic throttle | Onboard E-throttle |
| Data logging | 512 MB; 250 channels; aggregate rate up to 100 kHz |
| Software / communication | PCLink G4X / LTW 6-pin USB |
| Connector / termination | 2 × 34-pin Superseal / 4-1437290-0, 4-1437290-1 |
| Operating supply | 6.5–24 V DC |
| Maximum input voltage | 36 V maximum; normal operation remains 6.5–24 V |
| Operating current | 200 mA |
| Maximum continuous current draw | 5.5 A |
| Sensor power outputs | +5 V and +8 V |
| Analogue voltage signal range | 0–5 V from sensors or external controllers |
| Engine-control functions | Flex fuel, VVT, open / closed-loop boost and dual closed-loop lambda; I/O allocation required |
| Acceleration sensing | Built-in three-axis accelerometer |
| E-throttle output allocation | Aux 9 / 10 used by the throttle motor; unavailable for other simultaneous loads |
Sensor and driver connections
Connect sensor ground, power ground, 5 V reference and 0–5 V signals to their assigned pins. Match trigger type and edge, ignition power stages, and injector / solenoid impedance and current.
PCLink and first-start checks
Install the matching PCLink generation and drivers, then preserve the existing map and firmware details. Check static sensors, I/O tests, cranking sync and locked ignition timing. The matching F1 help explains detailed settings. G4X logging is limited to 100 kHz across all channels.
Reference documents
- Link G4X XtremeX — Quickstart Guide
- Document language: English
- Referenced chapters: Connector allocation, power, triggers, auxiliary outputs and PCLink
