Applicability
Applies to the stated manufacturer reference model; wiring must match the actual hardware revision.
Model and software
G4+ Fury provides eight injector, six ignition outputs and one internal LSU 4.9 wideband driver. Use PCLink G4+ and this generation’s A / B pinout; G4X memory or electrical specifications do not substitute.
I/O and electrical limits
A shared pin can perform only one function at a time. Check physical pin overlap when allocating CAN, digital inputs, throttle and auxiliary outputs.
| Item | Specification / revision condition |
|---|---|
| Version identification | Link G4+ generation |
| Injector outputs | 8 |
| Ignition outputs | 6 |
| Analogue inputs | 9 |
| Temperature inputs | 4 |
| Digital inputs | 10 physical assignments; DI9 / DI10 shared with CAN2 on supported hardware |
| Auxiliary outputs | 10 |
| Data logging | 4 MB; verify the hardware revision |
| Wideband lambda | One onboard Bosch LSU 4.9 interface |
| Electronic throttle | 1 internal E-throttle channel |
| Connector / termination | A + B |
| Software / communication | PCLink G4+ |
| Trigger inputs / signal | 2 inputs; reluctor, proximity, optical or Hall, configured for the engine |
| Analogue voltage range | 0–5 V sensor / external-controller signals |
| Sensor power outputs | +5 V and +8 V |
| Temperature sensor type | NTC thermistor inputs; use the matching pull-up / calibration settings |
| Knock inputs | 2 dedicated knock inputs |
| Spare output reuse | Spare injection / ignition outputs may become switching auxiliaries |
| CAN / hardware revision | CAN2 shares DI9 / DI10; plan eight remaining digital inputs when enabled |
| Electronic throttle allocation | Motor uses Aux 9 / Aux 10 |
Sensor and driver connections
Connect sensor ground, power ground, 5 V reference and 0–5 V signals to their assigned pins. Match trigger type and edge, ignition power stages, and injector / solenoid impedance and current.
PCLink and first-start checks
Install the matching PCLink generation and drivers, then preserve the existing map and firmware details. Check static sensors, I/O tests, cranking sync and locked ignition timing. The matching F1 help explains detailed settings.
Reference documents
- Link G4+ Fury — Quickstart Guide
- Document language: English
- Referenced chapters: Connector allocation, power, triggers, auxiliary outputs and PCLink
