Link Fury X ECU

FuryX has six ignition drives and onboard digital wideband; XtremeX has eight ignition drives and needs external wideband control. Their analogue-input counts also differ.

Yes. CAN2 shares two digital-input pins, leaving eight of the ten inputs available for other functions. Speed, switch and ethanol-content signals cannot reuse those occupied pins.

FuryX has eight injector and six ignition outputs for fully sequential control up to six cylinders or three rotors. Eight injector outputs do not provide eight ignition channels.

The ECU integrates the controller, not the exhaust sensor. Use the specified compatible oxygen sensor and wiring, and check whether they are included in the itemized package.

Normal operation is 6.5–24 V; 36 V is the maximum input limit. Design the supply and protection for the normal range, not continuous 36 V operation.

No. Dual closed-loop lambda is a control function using valid measured lambda channels. It is separate from the number of onboard wideband controllers. FuryX has one internal LSU 4.9 interface; XtremeX and MonsoonX need appropriate external wideband hardware.

No. FuryX analogue-voltage inputs are limited to 0–5 V. A higher-voltage output needs suitable signal conditioning. Verify the output specification separately from the sensor’s supply voltage before wiring.

The quick-start guide allows spare injection and ignition channels to be assigned to auxiliary functions. Their electrical driver limits still apply, and a channel already assigned to ignition or injection cannot simultaneously serve another load.

The PDF quick-start guide provides the model I/O and pin map. The complete wiring, function and software help is included in the matching PCLink generation and opens with F1. Use both the pin map and the function-specific help when assigning the harness.

In addition to trigger wiring and configuration, check the ECU enable/lock status. The Link quick-start guide states original new ECUs may be configured while locked but will not read engine RPM or run an engine until enabled. Confirm the actual supplied hardware’s status rather than assuming a wiring fault.

No. 100 kHz is the aggregate limit across up to 250 channels with 512 MB memory. Allocate rates by diagnostic need; it is not 100 kHz per channel.

The internal wideband interface connects to Bosch LSU 4.9. Use its matching connector and pinout; do not connect other LSU types or an external controller’s analogue output to those pins.